2025–2026 PA Appraisers
License Exam – Complete
Questions and Answers
(100% Verified & Satisfied),
Latest Updated Study Guide,
Test Bank, and Guaranteed
PASS A+ Preparation Material
,How is a diamond condition fixed? - CORRECT ANSWER-By
pulling the damage for length. Diamond is a length condition
When measuring a unibody vehicle, it is discovered that
the left front rail is 111mm from spec in width. What
condition is this? - CORRECT ANSWER-Width is calculated
from the center out, so a value of -111mm on the left
rail shows sway to the right and in toward centerline
A collision-damaged vehicle is discovered to be
down in height at the opposite end of the center
section. What condition is this frame in? - CORRECT
ANSWER-Twist condition
When diagnosing the damage to a full frame assembly
on a sport utility vehicle, it is determined that the left
side frame rail is higher than the right side frame rail.
Technician A says the damaged state is known as a twist
condition. Technician B says a sway condition exists.
Who is right? - CORRECT ANSWER-Tech A. When a frame
rail's relationship to the vehicle centerline is changed,
such as pushed either to the left or
right, the condition is known as sway. "Twist" refers to
the condition of the frame when entire sections are
driven higher or lower than the opposite side.
,Metal fillers contain different ingredients that provide
fillers with special properties. What benefit does
fiberglass provide? - CORRECT ANSWER-Fiberglass offers
more resistance to moisture
, What does HSLA stand for? - CORRECT ANSWER-
High Strength Low Alloy
When replacing the floor pan in the trunk area, what
joint should be used to join the new pan to the
existing floor? - CORRECT ANSWER-Overlap joint
When acoustical foam is removed during the repair,
what must happen afterwards? - CORRECT ANSWER-
Replace the acoustical foam
When setting up a three-dimensional measuring system, it
should be setup on an undamaged area, and start with what
section? - CORRECT ANSWER-Starting in the center section
What is the plastic Black box in rear of the car? -
CORRECT ANSWER-Vapor Canister
Grinding or squeaking from a wheel is a sign of
what? - CORRECT ANSWER-Bad bearings
License Exam – Complete
Questions and Answers
(100% Verified & Satisfied),
Latest Updated Study Guide,
Test Bank, and Guaranteed
PASS A+ Preparation Material
,How is a diamond condition fixed? - CORRECT ANSWER-By
pulling the damage for length. Diamond is a length condition
When measuring a unibody vehicle, it is discovered that
the left front rail is 111mm from spec in width. What
condition is this? - CORRECT ANSWER-Width is calculated
from the center out, so a value of -111mm on the left
rail shows sway to the right and in toward centerline
A collision-damaged vehicle is discovered to be
down in height at the opposite end of the center
section. What condition is this frame in? - CORRECT
ANSWER-Twist condition
When diagnosing the damage to a full frame assembly
on a sport utility vehicle, it is determined that the left
side frame rail is higher than the right side frame rail.
Technician A says the damaged state is known as a twist
condition. Technician B says a sway condition exists.
Who is right? - CORRECT ANSWER-Tech A. When a frame
rail's relationship to the vehicle centerline is changed,
such as pushed either to the left or
right, the condition is known as sway. "Twist" refers to
the condition of the frame when entire sections are
driven higher or lower than the opposite side.
,Metal fillers contain different ingredients that provide
fillers with special properties. What benefit does
fiberglass provide? - CORRECT ANSWER-Fiberglass offers
more resistance to moisture
, What does HSLA stand for? - CORRECT ANSWER-
High Strength Low Alloy
When replacing the floor pan in the trunk area, what
joint should be used to join the new pan to the
existing floor? - CORRECT ANSWER-Overlap joint
When acoustical foam is removed during the repair,
what must happen afterwards? - CORRECT ANSWER-
Replace the acoustical foam
When setting up a three-dimensional measuring system, it
should be setup on an undamaged area, and start with what
section? - CORRECT ANSWER-Starting in the center section
What is the plastic Black box in rear of the car? -
CORRECT ANSWER-Vapor Canister
Grinding or squeaking from a wheel is a sign of
what? - CORRECT ANSWER-Bad bearings
