FANUC ROBOT CERTIFICATION EXAM | FREQUENTLY TESTED QUESTIONS WITH CORRECT ANSWERS | BRAND NEW!

Page 1 of 12


FANUC ROBOT CERTIFICATION EXAM |
FREQUENTLY TESTED QUESTIONS WITH
CORRECT ANSWERS | BRAND NEW!




What instruction will send program flow out to a sub program?
a. JMP/LBL
b. REMARK
c. CALL
d. SELECT - ✔✔✔ Correct Answer > c. CALL


True/False QUICK/FULL menus can be accessed from the FCTN
key. - ✔✔✔ Correct Answer > True


What do you press to change coordinates to jog in JOINT mode? -
✔✔✔ Correct Answer > COORD




What direction does the robot move in the WORLD Z+ if floor
mounted? - ✔✔✔ Correct Answer > Upwards

, Page 2 of 12


What are two possible actions of an IF/SELECT statement? - ✔✔✔
Correct Answer > CALL and JMP/LBL




How would you increment Register 7 (R[7]) by 1? - ✔✔✔ Correct
Answer > R[7]=R[7]+1




True or false. PR data is valid globally through the controller. -
✔✔✔ Correct Answer > True




What does PR[1,3] = PR[1,3] + 15 mean? - ✔✔✔ Correct Answer > The
third element, Z coordinate, has 15mm added to it.


What is the Binary Bit Value for the following outputs? DO[1] and
DO[5]. - ✔✔✔ Correct Answer > 17


Configuring I/O establishes the correspondence between the
signal number and the physical port. Each signal, or signal-
sequence must be configured to a rack, a __________ in the rack,
and the starting point or channel number (for analog). - ✔✔✔
Correct Answer > Slot




Work Cell - ✔✔✔ Correct Answer > The robot and everything around
the robot that is associated with it.