COSMETOLOGY CLINICAL CERTIFICATION
PAPER 2026 FULL SOLUTIONS GRADED A+
⩥ to reduce tangling of the hair while rising the relaxer , use. Answer:
always rinse with warm water to remove all traces of the product and
avoid tangling.
⩥ To test for the existence of metallic dyes in the hair, place a strand of
hair in the following solution. Answer: 1 ounce 20 volume H202, 20
drops ammonia
⩥ Unless instructions say otherwise, to stop the action of a relaxer, the
stylist should. Answer: rinse with warm water
⩥ The use thinning shears is sometimes referred to as. Answer: thinning
shears can be used as a blending technique .
⩥ Use thinning or tapering shears to. Answer: Remove bulk
⩥ The volume of hydrogen peroxide may be reduced by diluting with.
Answer: Distilled Water
⩥ what is considered an average normal daily rate of hair loss due to the
three phrases of the hair growth cycle?. Answer: 35-40
,⩥ what is the degree of blunt haircut elevation ?. Answer: 0
⩥ what is the name for chemical reaction that occurs when H2O2 is
combined with bleach or aniline derivate tint. Answer: oxidation
⩥ When applying temporary color to hair , gloves should worn to.
Answer: Temporary color rinses can stain , so it is best to wear gloves.
Prevent staining of the skin.
⩥ When a blow dryer use a large diameter round brush to achieve ..
Answer: A loose wave
⩥ When cutting hair with electric clippers , the hair should be. Answer:
dry
⩥ when cutting the hair with a razor , the hair should be. Answer: damp
⩥ When giving a blunt haircut, you should begin cutting at the. Answer:
nape
⩥ When giving a heat wave with clamps, if a client complains about too
much heat on the neck, the cosmetologist should:. Answer: place cotton
under clamps
, ⩥ when giving a perm the porosity of hair determines to its ability to.
Answer: porosity determines the ability for substances ( such as liquids)
to pass through a material ( such as cuticle of hair )
⩥ When holding shears for cutting, where is the thumb placed?. Answer:
In the grip of movable blade.
⩥ when performing a chemical service , to protect the client 's clothing.
Answer: Have the client change into a gown
⩥ when performing a tint back to natural hair color , from a lighter color
, which of the following products is recommended. Answer: A color
filler
⩥ when performing a virgin lightening on the hair begin the application.
Answer: starting away from the scalp up to the ends
⩥ when performing a virgin sodium hydroxide relaxer , apply the
product. Answer: 1/2 inch from the scalp to the ends
⩥ When proceeding through subsections of haircut , the guideline is.
Answer: ..........................................................
PAPER 2026 FULL SOLUTIONS GRADED A+
⩥ to reduce tangling of the hair while rising the relaxer , use. Answer:
always rinse with warm water to remove all traces of the product and
avoid tangling.
⩥ To test for the existence of metallic dyes in the hair, place a strand of
hair in the following solution. Answer: 1 ounce 20 volume H202, 20
drops ammonia
⩥ Unless instructions say otherwise, to stop the action of a relaxer, the
stylist should. Answer: rinse with warm water
⩥ The use thinning shears is sometimes referred to as. Answer: thinning
shears can be used as a blending technique .
⩥ Use thinning or tapering shears to. Answer: Remove bulk
⩥ The volume of hydrogen peroxide may be reduced by diluting with.
Answer: Distilled Water
⩥ what is considered an average normal daily rate of hair loss due to the
three phrases of the hair growth cycle?. Answer: 35-40
,⩥ what is the degree of blunt haircut elevation ?. Answer: 0
⩥ what is the name for chemical reaction that occurs when H2O2 is
combined with bleach or aniline derivate tint. Answer: oxidation
⩥ When applying temporary color to hair , gloves should worn to.
Answer: Temporary color rinses can stain , so it is best to wear gloves.
Prevent staining of the skin.
⩥ When a blow dryer use a large diameter round brush to achieve ..
Answer: A loose wave
⩥ When cutting hair with electric clippers , the hair should be. Answer:
dry
⩥ when cutting the hair with a razor , the hair should be. Answer: damp
⩥ When giving a blunt haircut, you should begin cutting at the. Answer:
nape
⩥ When giving a heat wave with clamps, if a client complains about too
much heat on the neck, the cosmetologist should:. Answer: place cotton
under clamps
, ⩥ when giving a perm the porosity of hair determines to its ability to.
Answer: porosity determines the ability for substances ( such as liquids)
to pass through a material ( such as cuticle of hair )
⩥ When holding shears for cutting, where is the thumb placed?. Answer:
In the grip of movable blade.
⩥ when performing a chemical service , to protect the client 's clothing.
Answer: Have the client change into a gown
⩥ when performing a tint back to natural hair color , from a lighter color
, which of the following products is recommended. Answer: A color
filler
⩥ when performing a virgin lightening on the hair begin the application.
Answer: starting away from the scalp up to the ends
⩥ when performing a virgin sodium hydroxide relaxer , apply the
product. Answer: 1/2 inch from the scalp to the ends
⩥ When proceeding through subsections of haircut , the guideline is.
Answer: ..........................................................
