Question: What is a view projected from a primary auxiliary view called?
Give this one a try later!
Secondary auxiliary view
Question: Which type of projection method is typically used in the United States?
Give this one a try later!
Third Angle
,Question: __________ should be validated and approved to ensure accuracy.
Give this one a try later!
Standard operating procedures
Question: __________ welds are used to connect two plates using holes in one or both
plates to allow access for the welding tool.
Give this one a try later!
Plug and slot
Question: Parts are inspected __________ to make sure the typical characteristics of a
produced parts are found.
Give this one a try later!
Randomly
Question: Which of the following items can affect a micrometer's measurement?
Give this one a try later!
, Dust
Oil
Contaminants
Burrs
Question: What often happens if operators make adjustments to recently produced
parts based on recent measurements?
Give this one a try later!
Part variation will increase
Question: When the same type of arc is used in more than one place, what note is
included with the dimension?
Give this one a try later!
Typical (TYP)
Question: What occurs when performing inspections during quality control data
collection and analysis?
Give this one a try later!
Comparison of parts to a standard
, Question: Internal dimensions, like holes, are at their MMC when they are at their
__________ of their tolerance zone?
Give this one a try later!
Lower limit
Question: Statistical process control has two types of data. Which one is mostly used
with go/no go gauges?
Give this one a try later!
Attribute
Question: What is a good practice in analyzing an X-bar and R chart?
Give this one a try later!
Circle out-of-control patterns
Question: Product development teams should perform a(n) __________ as early as
possible during their design process.
Give this one a try later!
Give this one a try later!
Secondary auxiliary view
Question: Which type of projection method is typically used in the United States?
Give this one a try later!
Third Angle
,Question: __________ should be validated and approved to ensure accuracy.
Give this one a try later!
Standard operating procedures
Question: __________ welds are used to connect two plates using holes in one or both
plates to allow access for the welding tool.
Give this one a try later!
Plug and slot
Question: Parts are inspected __________ to make sure the typical characteristics of a
produced parts are found.
Give this one a try later!
Randomly
Question: Which of the following items can affect a micrometer's measurement?
Give this one a try later!
, Dust
Oil
Contaminants
Burrs
Question: What often happens if operators make adjustments to recently produced
parts based on recent measurements?
Give this one a try later!
Part variation will increase
Question: When the same type of arc is used in more than one place, what note is
included with the dimension?
Give this one a try later!
Typical (TYP)
Question: What occurs when performing inspections during quality control data
collection and analysis?
Give this one a try later!
Comparison of parts to a standard
, Question: Internal dimensions, like holes, are at their MMC when they are at their
__________ of their tolerance zone?
Give this one a try later!
Lower limit
Question: Statistical process control has two types of data. Which one is mostly used
with go/no go gauges?
Give this one a try later!
Attribute
Question: What is a good practice in analyzing an X-bar and R chart?
Give this one a try later!
Circle out-of-control patterns
Question: Product development teams should perform a(n) __________ as early as
possible during their design process.
Give this one a try later!
