AOPP NPQ ACTUAL PAPER 2026 QUESTIONS
WITH SOLUTIONS GRADED A+
◉ The correct vision with contact lenses or spectacles required by
NFPA 1582 is. Answer: 20/40
◉ The angle from the front point of ground contact of the front tire
to any projection of the apparatus in front of the front axle is
considered the. Answer: Angle of approach
◉ The fire apparatus with a primary purpose of transporting 1000
or more gallons of water is considered to be a/an. Answer:
Tanker/Tender
◉ The type of pumper which is usually equipped with 4 Wheel Dr.
and typically has a pump with a capacity of less than 500 GPM is
known as a. Answer: Minipumper
◉ Tandem rear axle, tri-axle, or a tractor trailer design should be
considered for tanks capacities greater than. Answer: 1,500 gallons
◉ Wildland fire apparatus are. Answer: Light weight, highly
maneuverable vehicles that can go places inaccessible to larger
apparatus
,◉ The correct method of extinguishing fires from a wildland fire
apparatus is to. Answer: Use short sections of attack hose while
walking along the apparatus and extinguishing fires along the way
◉ Blank is defined as keeping apparatus in a state of usefulness and
readiness. Answer: Maintenance
◉ Checking and documenting the oil level radiator coolant fuel
levels tire and visible and audible warning signals is normally
considered to be part of blank maintenance. Answer: Daily/weekly
◉ Checking for voltage electrolyte level and corrosion's are all steps
in inspecting. Answer: The battery
◉ Proper blank is one of the prime Objectives of good maintenance.
Answer: Lubrication
◉ When performing a capacity test the design net pump pressure
should be blank psi. Answer: 150
◉ Inspecting all valves would be considered a part of blank
maintenance. Answer: Daily
, ◉ One method of performing in apparatus/pretrip inspection is the.
Answer: Walk around method
◉ The manufacture manual would blank the society of automotive
engineers (S.A.E) number for the engine oil. Answer: Recommend
◉ The oil pressure gauge indicate the. Answer: Supply of oil being
delivered
◉ Two blank means to restore or replace that which has become
inoperable. Answer: Repair
◉ When performing road test the apparatus should be. Answer:
Fully loaded as it would be once in service
◉ An ammeter indicates the. Answer: Amount of current flowing
into the battery and the amount of current being taken from the
battery
◉ Which of the following conditions could be found while doing
routine maintenance on the battery. Answer: Loosely tiedowns and
corrosion around the battery connections
WITH SOLUTIONS GRADED A+
◉ The correct vision with contact lenses or spectacles required by
NFPA 1582 is. Answer: 20/40
◉ The angle from the front point of ground contact of the front tire
to any projection of the apparatus in front of the front axle is
considered the. Answer: Angle of approach
◉ The fire apparatus with a primary purpose of transporting 1000
or more gallons of water is considered to be a/an. Answer:
Tanker/Tender
◉ The type of pumper which is usually equipped with 4 Wheel Dr.
and typically has a pump with a capacity of less than 500 GPM is
known as a. Answer: Minipumper
◉ Tandem rear axle, tri-axle, or a tractor trailer design should be
considered for tanks capacities greater than. Answer: 1,500 gallons
◉ Wildland fire apparatus are. Answer: Light weight, highly
maneuverable vehicles that can go places inaccessible to larger
apparatus
,◉ The correct method of extinguishing fires from a wildland fire
apparatus is to. Answer: Use short sections of attack hose while
walking along the apparatus and extinguishing fires along the way
◉ Blank is defined as keeping apparatus in a state of usefulness and
readiness. Answer: Maintenance
◉ Checking and documenting the oil level radiator coolant fuel
levels tire and visible and audible warning signals is normally
considered to be part of blank maintenance. Answer: Daily/weekly
◉ Checking for voltage electrolyte level and corrosion's are all steps
in inspecting. Answer: The battery
◉ Proper blank is one of the prime Objectives of good maintenance.
Answer: Lubrication
◉ When performing a capacity test the design net pump pressure
should be blank psi. Answer: 150
◉ Inspecting all valves would be considered a part of blank
maintenance. Answer: Daily
, ◉ One method of performing in apparatus/pretrip inspection is the.
Answer: Walk around method
◉ The manufacture manual would blank the society of automotive
engineers (S.A.E) number for the engine oil. Answer: Recommend
◉ The oil pressure gauge indicate the. Answer: Supply of oil being
delivered
◉ Two blank means to restore or replace that which has become
inoperable. Answer: Repair
◉ When performing road test the apparatus should be. Answer:
Fully loaded as it would be once in service
◉ An ammeter indicates the. Answer: Amount of current flowing
into the battery and the amount of current being taken from the
battery
◉ Which of the following conditions could be found while doing
routine maintenance on the battery. Answer: Loosely tiedowns and
corrosion around the battery connections
