Module 2 : Equipment and Stability Constraints in System Operation
Lecture 9 : Voltage Instability
Objectives
In this lecture you will learn the following
What is voltage instability ?
Voltage Instability
Voltage Instability is another stability problem that may manifest under heavy loading conditions. This problem
causes extremely low voltages. It stems due to the actions of loads to demand power which is beyond the
capability of the generators and the transmission network.
To understand this, consider a system shown below. As the load resistance decreases, the voltage at the load
bus falls while power is expected to increase. However, a point comes beyond which the load power decreases
as resistance falls. This occurs at R=X (the maximum power point) --- show this!
(click to enlarge) (click to enlarge)
Now, suppose the load is not a constant resistance, but is a controlled resistance which tries to keep load
power constant by decreasing resistance if power is less than the desired value. This is all fine if the desired
power is less than the maximum power point. If the desired power is greater than the maximum power point,
the system will never reach an equilibrium because beyond the maximum power point, the controller action
reduces the resistance, which reduces power and further pulls down the voltage. Usually any controller will
have limits because of which controller action will cease beyond a point. However, the "damage has been
done", in the sense that load voltage will be very low.
Voltage Instability (Con td..)
A controlled resistance which maintains constant power can be implemented using a tap changing transformer
feeding a constant resistance. The tap value is changed if voltage at load is not equal to the desired value.
Therefore the reflected resistance on the system side is controlled.
Lecture 9 : Voltage Instability
Objectives
In this lecture you will learn the following
What is voltage instability ?
Voltage Instability
Voltage Instability is another stability problem that may manifest under heavy loading conditions. This problem
causes extremely low voltages. It stems due to the actions of loads to demand power which is beyond the
capability of the generators and the transmission network.
To understand this, consider a system shown below. As the load resistance decreases, the voltage at the load
bus falls while power is expected to increase. However, a point comes beyond which the load power decreases
as resistance falls. This occurs at R=X (the maximum power point) --- show this!
(click to enlarge) (click to enlarge)
Now, suppose the load is not a constant resistance, but is a controlled resistance which tries to keep load
power constant by decreasing resistance if power is less than the desired value. This is all fine if the desired
power is less than the maximum power point. If the desired power is greater than the maximum power point,
the system will never reach an equilibrium because beyond the maximum power point, the controller action
reduces the resistance, which reduces power and further pulls down the voltage. Usually any controller will
have limits because of which controller action will cease beyond a point. However, the "damage has been
done", in the sense that load voltage will be very low.
Voltage Instability (Con td..)
A controlled resistance which maintains constant power can be implemented using a tap changing transformer
feeding a constant resistance. The tap value is changed if voltage at load is not equal to the desired value.
Therefore the reflected resistance on the system side is controlled.
