Wood Shop Safety Test Study Guide Complete Questions with 100% Correct Answers

Wood Shop Safety Test Study Guide Complete Questions with 100% Correct Answers What is the margin of safety? 4 inches. When using a saw, never... Feed the material faster than the saw blade can remove the wood easily. The palm sander is used for what? removing small amounts of material slowly. All small work should be secured with what? A clamp or vise. Make all adjustments on all power tools with the power off, except... When adjusting the speed of the lathe. Always cut.. Away from yourself when using a chisel, knife or any edged tool. What does it mean when your wood chips are burnt when you are drilling? Your drill bit is dull. The shortest board that can be safely run through the planer is... 12 inches. The belt sander is used for what? removing large amounts of material fast. The power miter box is used for what? Cutting angles, bevels, and crosscutting. The most material you can take off on the planer at one time is... One turn per pass. How long does the board have to be to run through the performax sander? 12 inches long. Then widest board that can be run through the planer is... 16 inches. When crosscutting on the table saw you should use what? The miter gauge. When ripping on the table saw you should use the... rip fence. The most you can take off with the performax sander per pass is... 1/8 of a turn. You should never reach behind or in front of... The blade on the power miter box. The blade on the table saw should extend about... 1/8" above the material when making a through cut. When using a band saw, how should you make turns? Make turns carefully and do not bend the blade. When using a band saw, what does it mean if you hear a clicking or screeching sound? The blade is bent or broken. When using a band saw, what type of cuts should you use to make sharp curves? Make relief cuts. The guard on the band saw should be set... 1/8" to 1/4" above the material you are cutting. What is the chuck key used for? To change the bits in the drill press. It is not ok to drill without... Having the material clamped securely. The person helping the operator of the table saw must only... Float the board not push or pull it. When using the table saw it is never ok to... Free hand a board which means cutting without the use of the fence or miter gauge. When using the table saw never set anything on... The left side of the fence.