CSA W59 WELDING INSPECTOR LEVEL
1 QUESTIONS WITH 100% CORRECT
ANSWERS { GRADED A+}
3.1 Contractors
In the absence of specific requirements in the governing design standard
, at the option of the engineer what other standards shall the contractor
be certified too ? If no standard is required what shall the contractor
prove ? - ✔✔W47.1
The contractor must prove their compentency to the engineer.
3.1.2 Welding processes
,What processes are covered by this standard ? - ✔✔SMAW, GMAW,
MCAW, FCAW, SAW, ESW, EGW, SW
Filler metals and allied materials are classified under what standard ? -
✔✔CSA W48
What processes filler metals and other materials not covered under CSA
W48? - ✔✔Stud welding is not covered under CSA W48. It shall
conform to the requirements of clause 3.1.2.2
Any welding process not covered by CSA W59 or not written into this
standard shall be covered under the acceptance criteria of what other
standard ? - ✔✔CSA W47.1
3.1.3 Prequalified joints
What processes are deemed pre qualified as long as they conform to
what clause ? And therefore are approved for use with out joint welding
qualification providing that welding procedures also conform to clause
, 4,5,10 - ✔✔SMAW, SAW, FCAW, MCAW (spray transfer) and
GMAW (spray transfer) as long as they conform to clause 10 shall be
deemed as prequalified .
3.2 Base metal
Steel base metal to be welded under this standard shall conform to what
standard?
*equivalent welding quality shall be established on the basis of
composition and carbon equivalent - ✔✔Steel material to be welded
should conform to CSA or ASTM requirements
What CSA standard shall steel base metal that is to be welded conform
to ? - ✔✔CSA G40.21
4.1 Design of welded connections
1 QUESTIONS WITH 100% CORRECT
ANSWERS { GRADED A+}
3.1 Contractors
In the absence of specific requirements in the governing design standard
, at the option of the engineer what other standards shall the contractor
be certified too ? If no standard is required what shall the contractor
prove ? - ✔✔W47.1
The contractor must prove their compentency to the engineer.
3.1.2 Welding processes
,What processes are covered by this standard ? - ✔✔SMAW, GMAW,
MCAW, FCAW, SAW, ESW, EGW, SW
Filler metals and allied materials are classified under what standard ? -
✔✔CSA W48
What processes filler metals and other materials not covered under CSA
W48? - ✔✔Stud welding is not covered under CSA W48. It shall
conform to the requirements of clause 3.1.2.2
Any welding process not covered by CSA W59 or not written into this
standard shall be covered under the acceptance criteria of what other
standard ? - ✔✔CSA W47.1
3.1.3 Prequalified joints
What processes are deemed pre qualified as long as they conform to
what clause ? And therefore are approved for use with out joint welding
qualification providing that welding procedures also conform to clause
, 4,5,10 - ✔✔SMAW, SAW, FCAW, MCAW (spray transfer) and
GMAW (spray transfer) as long as they conform to clause 10 shall be
deemed as prequalified .
3.2 Base metal
Steel base metal to be welded under this standard shall conform to what
standard?
*equivalent welding quality shall be established on the basis of
composition and carbon equivalent - ✔✔Steel material to be welded
should conform to CSA or ASTM requirements
What CSA standard shall steel base metal that is to be welded conform
to ? - ✔✔CSA G40.21
4.1 Design of welded connections
