Page |1
ADVANCE RIGGER TEST – ACTUAL EXAM
WITH 100% VERIFIED QUESTIONS AND
CORRECT ANSWERS|EXCELLENT SCORES
What is meant by the term "two blocking"?
a. Placing blocks under the outrigger beams.
b. The load block contacts the boom point sheaves.
c. Stacking loads on top of one another.
d. The load strikes the boom while swinging. - correct-answer-b. The
load block contacts the boom point sheaves.
Lifting 20,000 lbs with a 2-leg bridle sling at a 30° horizontal sling angle,
what is the force applied to each leg?
a. 10,000 pounds
b. 20,000 pounds
c. 30,000 pounds
d. 40,000 pounds - correct-answer-b. 20,000 pounds
, Page |2
In multiple crane lifts using an equalizer beam, the weight of the beam
should be considered:
a. Part of the crane boom
b. Part of the load weight
c. Part of the crane weight
d. A non-factor - correct-answer-b. Part of the load weight
What is required if there is a deviation from the lift plan?
a. The supervisor's permission
b. The rigger's permission
c. A new lift plan
d. Mark ups on the existing lift plan - correct-answer-c. A new lift plan
On level ground using skids and rollers, what percent of the weight of
the load should yield the required line pull as a general rule of thumb?
a. 2%
, Page |3
b. 5%
c. 10%
d. 20% - correct-answer-b. 5%
All of the following are results of unbalanced reeving of the hook block
EXCEPT:
a. Wear on the sheaves
b. Torque on the boom
c. Wear on the hook
d. Wear on the wire rope - correct-answer-c. Wear on the hook
Before a spreader bar or beams can be used they MUST have been:
a. Repainted
b. Used before
c. Tested and approved
d. Upgraded from the previous job - correct-answer-c. Tested and
approved
ADVANCE RIGGER TEST – ACTUAL EXAM
WITH 100% VERIFIED QUESTIONS AND
CORRECT ANSWERS|EXCELLENT SCORES
What is meant by the term "two blocking"?
a. Placing blocks under the outrigger beams.
b. The load block contacts the boom point sheaves.
c. Stacking loads on top of one another.
d. The load strikes the boom while swinging. - correct-answer-b. The
load block contacts the boom point sheaves.
Lifting 20,000 lbs with a 2-leg bridle sling at a 30° horizontal sling angle,
what is the force applied to each leg?
a. 10,000 pounds
b. 20,000 pounds
c. 30,000 pounds
d. 40,000 pounds - correct-answer-b. 20,000 pounds
, Page |2
In multiple crane lifts using an equalizer beam, the weight of the beam
should be considered:
a. Part of the crane boom
b. Part of the load weight
c. Part of the crane weight
d. A non-factor - correct-answer-b. Part of the load weight
What is required if there is a deviation from the lift plan?
a. The supervisor's permission
b. The rigger's permission
c. A new lift plan
d. Mark ups on the existing lift plan - correct-answer-c. A new lift plan
On level ground using skids and rollers, what percent of the weight of
the load should yield the required line pull as a general rule of thumb?
a. 2%
, Page |3
b. 5%
c. 10%
d. 20% - correct-answer-b. 5%
All of the following are results of unbalanced reeving of the hook block
EXCEPT:
a. Wear on the sheaves
b. Torque on the boom
c. Wear on the hook
d. Wear on the wire rope - correct-answer-c. Wear on the hook
Before a spreader bar or beams can be used they MUST have been:
a. Repainted
b. Used before
c. Tested and approved
d. Upgraded from the previous job - correct-answer-c. Tested and
approved
