NIMS CNC Mill Certification
A drill chuck style tool holder can be used to maintain smaller endmills (T/F) - ANS-False
Activates round interpolation clockwise - ANS-G02
Activates round interpolation counterclockwise - ANS-G03
Activates deep-hollow p.C. Drilling cycle - ANS-G83
Activates fast-percent drilling cycle - ANS-G73
Activates linear interpolation - ANS-G01
Activates unmarried-pass drilling - ANS-G81
Activates unmarried-bypass drilling with reside - ANS-G82
At this depth, p.C. Drilling should be used as opposed to unmarried pass drilling - ANS-3 times
the diameter of the drill bit
Attributes of a collet style tool holder - ANS-Provide minimum runout but also have minimum
protecting electricity. Should not be used in high torque operations.
Coolant off - ANS-M09
Coolant on - ANS-M08
Indicates cease of canned cycle - ANS-G80
Indicates the Z coordinate that a tool returns to after every operation in a canned cycle -
ANS-R-cost/R-aircraft
P-word fee that equals one 2d - ANS-P1000
Plunge Cutting - ANS-When a endmill is plunged immediately into the fabric, much like a drill bit.
Sets the gap drilled in-among every p.C. Cycle - ANS-Q-phrase
Sets the dwell time for a unmarried bypass drilling cycle with live - ANS-P-phrase
A drill chuck style tool holder can be used to maintain smaller endmills (T/F) - ANS-False
Activates round interpolation clockwise - ANS-G02
Activates round interpolation counterclockwise - ANS-G03
Activates deep-hollow p.C. Drilling cycle - ANS-G83
Activates fast-percent drilling cycle - ANS-G73
Activates linear interpolation - ANS-G01
Activates unmarried-pass drilling - ANS-G81
Activates unmarried-bypass drilling with reside - ANS-G82
At this depth, p.C. Drilling should be used as opposed to unmarried pass drilling - ANS-3 times
the diameter of the drill bit
Attributes of a collet style tool holder - ANS-Provide minimum runout but also have minimum
protecting electricity. Should not be used in high torque operations.
Coolant off - ANS-M09
Coolant on - ANS-M08
Indicates cease of canned cycle - ANS-G80
Indicates the Z coordinate that a tool returns to after every operation in a canned cycle -
ANS-R-cost/R-aircraft
P-word fee that equals one 2d - ANS-P1000
Plunge Cutting - ANS-When a endmill is plunged immediately into the fabric, much like a drill bit.
Sets the gap drilled in-among every p.C. Cycle - ANS-Q-phrase
Sets the dwell time for a unmarried bypass drilling cycle with live - ANS-P-phrase
